Glass Panel
MVP-50P Piston
MVP-50P Turboprop
Engine Analyzers
UBG-16 Bar Graph
US-8A (16 Channels)
SR-8A (8 Channels)
Fuel Flow/Pressure
Primary
Standard
RPM
R-1 Tachometer
Manifold Pressure
M-1 Manifold Pressure
Volts & Amps
VA-1A Voltammeter
Oil Pressure/Temp
OPT-1 Press/Temp
Fuel Level
FL-2 Dual Level
FL-1 Single Level
Temp Instruments
Single Channel
Multi-Channel
Remote Switches
Primary Remote Switches
Clocks
ASC-5A Altitude Clock
SC-5 Super Clock
Turboprop
R-1 N1 (NG)
R-1 N2 (NP)
M-1-ITT
M-1-T (Torque)
M-1-TOT
Accessories
Annunciators
Probes
Pressure Transducers
Flow Transducers

FL-2

FL-2 Specifications
Multi

MVP
Fl-2 Specifications


Specifications

Dimensions
2.5" x 2.5" x 3.65" Depth, 2.25" Bezel

Analog Display
Two sets of 7 High Intensity Light Emitting Diodes (LEDs) in 90 degree arcs with Intensity Control Line available for dimming. Sequential flash test on power up.

Power Requirements
7.5 to 35 volts, 1/10 Amp.


LED Warnings

1/4 Tank Warning
If the left or right tank level reaches 1/4 of a tank, the appropriate yellow LED will blink.

Low Fuel
If the left or right tank reaches 1/8 of a tank, the appropriate red LED will blink.

"OPEN" Warning
If the wire to the left or right fuel tank sensor becomes open, the analog display for the tank with the problem will show an empty and the digital display will show "OPEN."

Note
To acknowledge a blinking LED (i.e., to stop the blinking), change the position of the Tank Selector Switch.

Max, Min and Resolution
Minimum fuel level for each tank: 4 gallons. Maximum fuel level for each tank: 999 gallons. Resolution: Programmable to 1 or 1/2 Gallon (Fuel levels below 2 gallons will be displayed as "0").

External Warning Control Line
Grounds when any Red Warning LED is on or yellow LED blinking. Current should be limited to 1/10 amp.

Intensity Control
Independent control lines allow pilots to adjust the intensity of both the Green Indicator Lights and the LCD Backlight during instrument operations.


\